Redline Communications RDL-2000 Manual de usuario Pagina 33

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 51
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 32
RDL-2000 User Manual
70-00143-01-01 Proprietary Redline Communications © 2011 Page 33 of 52 March 9, 2011
3.7 Software Screen
Use this screen to view information about the software files loaded on the RDL-2000.
The RDL-2000 contains non-volatile RAM storage for two versions of system software.
The active software banks (versions loaded at power-up/reboot) are highlighted in
yellow. The designation N/A in the banks field indicates that no (valid) software is
loaded in that bank. Both banks may contain the same version of RDL-2000 software.
Use the Firmware screen to upload new software and to change the selected active
software bank.
Figure 20: Link Mgr - Software Screen
Bank: Identifies the memory bank where the binary file is saved.
Boot Loader: General program to validate and load the RDL-2000 system-specific
software at power-up/reboot.
Firmware Bank 1: First memory bank for software file (SW1 in Firmware screen).
Firmware Bank 1: Second memory bank for software file (SW2 in Firmware screen).
Size (bytes): The size of the file.
Version: The software version of the stored file.
Date: The date the file was created.
Time: The time the file was created.
Checksum: The checksum (hex) for the file.
PCB Version: The version number of the printed circuit board.
PCA Version: The version number of the hardware assembly.
4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
Vista de pagina 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 50 51

Comentarios a estos manuales

Sin comentarios