Redline Communications RDL-2000 Manual de usuario descargar pdf (Pagina 11)

RDL-2000 User Manual

1.2.2 UL Information

1. The suitability of the supplied Ethernet cable is subject to the approval of Authority

Having Jurisdiction and must comply with the local electrical code.

2. The equipment must be properly grounded according with NEC and other local

safety code and building code requirements

3. To meet the over-voltage safety requirements on the telecommunications cables, a

minimum 26 AWG telecommunication line cord must be used.

4. "Pour être en conformance avec les exigences finies de sûreté de sur-tension sur les

câbles de télécommunications un fil de télécommunication ayant un calibre minimum

de 26 AWG doit être utilisé."

5. Reminder to all the BWA system installers: Attention to Section 820-40 of the NEC

which provides guidelines for proper grounding and, in particular, specifies that the

cable ground shall be connected to the grounding system of the building, as close to

the point of cable entry as is practical.

6. RDL-2000 must be installed in compliance with relevant articles in National Electrical

Code-NEC (and equivalent Canadian Code-CEC) including referenced articles 725,

800 and 810 in NEC.

7. RF coaxial cable connecting an antenna to the RDL-2000 must comply with the local

electrical code.

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 50 51

Sin comentarios

Redline Communications RDL-2000 Manual de usuario Pagina 11